Grooved Couplings Fittings - Zurn

No Results Found.

If you want to learn more, please visit our website CNG.

Go to Home page or try browsing all products.

No Results Found.

Go to Home page or try browsing all products.

I am modeling Standard A53-B s/40 ASME B36.10 Pipe w/grooved fittings and when I produce ISO's, I notice that for a standard 20' length pipe, the next connection shows FW instead of Grooved Coupling, to connect the pipe.

If you are looking for more details, kindly visit grooved couplings manufacturer.

Featured content:
Metric vs BSP: Cross Reference Guide - LinkedIn

Has anyone come across this while modeling grooved pipe and how to go about fixing the issue?

Is this a program issue or am I using the correct pipe in order to make a grooved coupling connection on standard pipe length.

A little more information, sure, so I am modeling a system that require the use grooved fittings. As you know in Plant 3D, you just run linear feet of pipe and when you produce an ISO, you will see the joining of pipe will be will be either FW, Threaded, or Grooved Coupling.  This is where I need help on.  I need for my installation of joining of pipe need to be grooved coupling instead of FW, if this makes sense. 

I am not sure if this is a pipe issue or a default in the software to show FW

If it is a field weld, how does it look in the 3D model? what type of connector is used. How are your connection settings. What are the endcodes of the connected ports? That really is very little information for us to go on.

For more information, please visit Industrial Grooved Piping Solution.